Technician inspecting a subfloor vent on a weatherboard house for rodent entry

Borer · Ponsonby

Borer Treatment Ponsonby

Workers' cottages and villas on narrow sections, built before 1910 and renovated many times since. We check the crawl space, the roof and the old lean-to before quoting.

Borer in Ponsonby: what to expect

Most Ponsonby houses we look at were built between the 1880s and about 1910, from native timber that was never treated against borer, so old flight holes are expected. What matters is whether any zone is still active. In Ponsonby that is most often the floor framing under the original front rooms, where the crawl space is low and rarely visited, and the floorboards of the back lean-to. A roof void treatment starts from about $350 and a subfloor from about $750, including GST.

Ponsonby houses: what they are built from

Ponsonby was cut into small sections in the late 1800s, and much of what still stands is the first generation of houses: single-storey workers' cottages with a lean-to kitchen at the back, and bay or corner villas on slightly wider lots. Framing is usually rimu or kauri, floors are often kahikatea or rimu tongue-and-groove, and the outside is rusticated weatherboard. None of it was boron-treated, because that process did not come into general use until the 1950s.

Most of these houses have been altered several times. A typical Ponsonby cottage now has three or four floor levels: the original front rooms on piles, a lean-to on its own lower piles, a 1970s or 1980s bathroom, and a recent kitchen or deck in treated pine. Borer rarely crosses into the newer treated timber, so the job is to find which of the old sections are still active and leave the rest alone.

Main build era
1880s to about 1910
Typical house
Single-storey cottage or bay villa on a narrow section
Borer seen most
Common house borer (Anobium punctatum)
Zone most often active
Subfloor framing under the original rooms
Access issue
Low crawl space, tight side path

Hotspots

Where borer shows up in Ponsonby homes

Under the original front rooms

The crawl space under a cottage is often 300 to 400 mm high at the street end, so few owners or builders have ever gone in. That is where we most often find fresh bore dust on bearers and the underside of floorboards.

The lean-to floor

Back lean-tos were often built more cheaply, with kahikatea boards laid close to the ground. Kahikatea sapwood is one of the timbers house borer favours, and a damp lean-to floor stays attractive to it.

Skirtings and door frames in hallways

Fine gritty dust on the hallway floor in November or December, below a skirting or architrave, usually means beetles have just emerged from timber right above it.

Roof framing over the bay

The roof over a bay villa's front room is often a separate, small void. Adults emerging there in early summer can be dealt with by an aerosol treatment during the flight season.

Getting into a Ponsonby house

Side paths are often less than a metre wide and some sections share a boundary wall, so we carry gear in by hand and keep it to what fits. Subfloor access is usually a small door at the rear of the base boards or a hatch in a cupboard. If a crawl space is too low for a safe inspection, we say so and work from the access points and any lifted boards, rather than guessing.

Many Ponsonby streets have residents' parking limits, so tell us when you book if there is off-street space or a visitor permit. If your house is in a special character area, ask the council before replacing original weatherboards that borer has damaged; treating them is not restricted.

Borer treatment cost in Ponsonby

A Ponsonby cottage with activity only in the roof space is at the low end, from about $350 including GST. Subfloor treatment starts from about $750, and in a low crawl space the price sits towards the top of our typical $350 to $950 range because the work is slower. Lean-to floors and individual pieces of furniture are priced after we have seen them. The quote lists each zone separately, so you can choose to treat only what is active.

Questions

Borer treatment in Ponsonby: questions

Our cottage crawl space is too low to get into. Can you still treat it?
Often, yes. We work from the access door and any hatches with a long lance, and where needed we lift one or two boards in a cupboard or under a rug to reach the middle of the floor. If part of the subfloor cannot be reached at all, the quote says so, and we do not charge for timber we cannot treat. For timber you can reach yourself, see how to treat borer in NZ.
The lean-to and the main house have different floors. Do they need separate treatment?
They are priced as separate zones, because they are often in different condition. It is common in Ponsonby for the front rooms to show only historic holes while the lean-to floor is active, or the other way around. We record each one as active, historic or clear.
We have a new kitchen extension in treated pine. Is that at risk?
Very unlikely. Modern framing is boron-treated to hazard class H1.2, which protects it against borer. The risk stays in the original native timber next to it, so we check the junction where old and new framing meet.
Is November a good time to treat borer in Ponsonby?
Yes. House borer adults are emerging from about October to February, so a roof void treatment now catches them before they lay eggs, and fresh dust is easiest to spot, which makes the inspection more accurate.

Close by, we also cover borer treatment in Grey Lynn and Mount Eden. For the species, the treatment steps and the flight season in detail, go back to borer treatment in Auckland.

For other pests in the area, see pest control in Central Auckland.

Seen fresh borer dust in Ponsonby?

Tell us if the crawl space is low or the side path is narrow, and whether the lean-to has its own floor. That is enough for a first price.

Free estimate · No obligation · Auckland-wide

Call now Free estimate